TM 5-3895-373-20A. REMOVE Continued.e.Loosen hex nut (19) on clevis (20).f.Remove cotter pin (21) from clevis pin (22).Discard cotter pin.g.Remove clevis pin (22) from clevis (20) anddisconnect clevis from throttle lever (23).h.Remove clevis (20) from throttle control cable(14).i.Loosen hex nut (24).j.Pull throttle control cable (14) from throttle cablebracket (25) and remove the throttle controlcable from the paving machine.k.Measure threads from washer (26). Record onillustration. This measurement is needed duringinstallation.B. INSTALL.1. INSTALL THROTTLE CONTROL CABLE.NOTEIf installing replacement throttle,cable hex nuts and washers will besupplied assembled to throttlecontrol cable.a.Adjust hex nut (27) and washer (26) on throttlecontrol cable (14) to measurement recorded instep A.2.k.b.Slide throttle control cable (14) through throttlecable bracket (25).c.Tighten hex nut (24) and washer (28) finger tightagainst throttle cable bracket (25).d.Install hex nut (19) and clevis (20) onto throttlecontrol cable (14). Do not install cotter pin (21) orclevis pin (22) at this time.GO TO NEXT PAGE4-71
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business