TM 5-3895-373-20
4.12.
REPLACE THROTTLE ACTUATOR AND THROTTLE CONTROL CABLE - Continued.
C.
ADJUST.
Throttle actuator must travel to the
end of stroke, in both directions,
when throttle control switch is in the
MAX or idle positions. If the throttle
actuator is not allowed to reach full
stroke
in
both
directions,
then
position current will continue to flow
after the actuator has physically
stopped and severe damage to the
actuator will occur.
1.
ADJUST FUEL INJECTION PUMP ENGINE
IDLE SPEED.
a.
Remove
electrical
connector
cover
from
STE/ICE DCA-4. Connect STE/ICE-R, using
cable W-I, between STE/ICE DCA-4 connector
and STE/ICE-R. Perform confidence test per
TM 9-4910-571-12&P.
b.
Start engine per TM 5-3895-373-10.
c.
Set STE/ICE-R for test 10 per TM 9-4910-571-
12&P.
d.
Move throttle lever (23) against high speed set
screw (29). STE/ICE-R engine speed should be
between 2600 rpm and 2680 rpm. If engine
speed is within specifications, go to step g.
e.
Remove antipilferage seal (30) and wire rope
(31). Remove sleeve (32).
GO TO NEXT PAGE
4-74
