TM 5-3895-373-20
4.12.
REPLACE THROTTLE ACTUATOR AND THROTTLE CONTROL CABLE.
This task covers:
a. Remove
b.
Install
c.
Adjust
INITIAL SETUP
Tools:
References:
General mechanic’s automotive tool kit
TM 5-3895-373-10
(Item 54, Appendix E)
TM 5-3895-373-24P
Materials/Parts:
Equipment Condition:
Electrical insulating compound (Item 11, Appendix C)
Right access door opened per TM 5-3895-373-10.
Cotter pin
Front top left access door opened per TM 5-3895-373-10.
Throttle actuator
Front top right access door opened per TM-5893-373-10.
Throttle control cable
Self-locking hex nuts
A.
REMOVE.
1.
REMOVE THROTTLE ACTUATOR.
a.
Disconnect engine harness electrical connector
(1) from throttle actuator electrical connector (2).
b.
Remove self-locking hex nut (3), flat washer (4),
and hex head cap screw (5). Discard self-locking
hex nut.
c.
Remove shoulder screw (6) and washer (7) from
sliding block (8).
d.
Remove self-locking hex nut (9) and hex head
cap screw (10). Discard self-locking hex nut.
e.
Remove throttle actuator (11) from actuator
mounting bracket (12).
GO TO NEXT PAGE
4-69
