2. ATTACH AND TIGHTEN THROTTLE CONTROL CABLE.

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
612

TM 5-3895-373-20 4.12. REPLACE THROTTLE ACTUATOR AND THROTTLE CONTROL CABLE - Continued. C. ADJUST Continued. 2. ATTACH AND TIGHTEN THROTTLE CONTROL CABLE. a. Turn ignition switch to the ON position per TM 53895-373-10. b. Set throttle control switch to MAX position. Ensure that the throttle actuator is fully retracted. c. Turn ignition switch to the STOP position per TM 53895-373-10. d. Move throttle lever (23) against high speed set screw (29). Adjust clevis (20) so that clevis pin (22) fits through both clevis and throttle lever. Install clevis pin. e. Install cotter pin (21) into clevis pin (22). f. Tighten hex nut (19) against clevis (20). g. Position ignition switch to ON position per TM 53895-373-10. h. Set throttle control switch to IDLE. Check position of throttle lever (23). Throttle lever should be just touching low speed set screw (34) without putting pressure on throttle lever or throttle control cable (14). i. If throttle lever (23) is: just touching low speed set screw (34) go to step m tight against low speed set screw (34), go to step j. not touching low speed set screw (34) go to step k. GO TO NEXT PAGE 4-76

Privacy Statement
Press Release
Contact