TM 5-3895-373-20
C.
ADJUST - Continued.
f.
Loosen nut (33) and adjust high speed set screw
(29) for a reading of 2650 rpm on STE/ICE-R.
Tighten nut.
g.
Move throttle lever (23) against low speed set
screw (34). STE/ICE-R engine speed should be
between 500 rpm and 850 rpm. If engine speed
is within specifications, go to step i.
h.
Loosen nut (35) and adjust low speed set screw
(34) for a reading of 650 rpm on STEIICE-R.
i.
Shut down engine per TM 5-3895-373-10.
j.
Install sleeve (32) over high speed set screw
(29). Route wire rope (31) through sleeve and
over threads of high speed set screw. Twist wire
rope and install and crimp antipilferage seal (30)
over wire rope.
GO TO NEXT PAGE
4-75
