TM 5-3895-373-20
4.12.
REPLACE THROTTLE ACTUATOR AND THROTTLE CONTROL CABLE - Continued.
A.
REMOVE Continued.
2.
REMOVE THROTTLE CONTROL CABLE.
a.
Loosen hex nut (13) but leave it flush against
sliding block (8).
b.
Unthread sliding block (8) and remove it from
throttle control cable (14). Measure threads from
hex nut (13) to end of the throttle control cable.
Record on illustration. This measurement is
needed during installation. Remove hex nut.
c.
Remove hex nut (15) and washer (16) and pull
throttle control cable out of actuator mounting
bracket (12).
d.
Measure threads from washer (17). Record on
illustration. This measurement is needed during
installation. Remove washer and hex nut (18).
GO TO NEXT PAGE
4-70