2. INSTALL THROTTLE ACTUATOR

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
609

TM 5-3895-373-20 B. INSTALL Continued. 2. INSTALL THROTTLE ACTUATOR. a. Slide rod end of throttle actuator (11) into sliding block (8). Secure in place with hex head cap screw (5), flat washer (4), and self-locking hex nut (3). b. Install throttle actuator (11) into actuator mounting bracket (12). Secure in place with hex head cap screw (10) and self-locking hex nut (9). Sliding block is made of plastic. If the shoulder screw is overtightened, the threads in the sliding block can be stripped. c. Install shoulder screw (6) and washer (7) through actuator mounting bracket (12) and into sliding block (8). Hand tighten shoulder screw with allen key until it bottoms in sliding block. Do not overtighten shoulder screw or threads in sliding block can be stripped. d. Apply electrical insulating compound to throttle actuator electrical connector (2). e. Connect engine harness electrical connector (1) to throttle actuator electrical connector (2). GO TO NEXT PAGE 4-73

Privacy Statement
Press Release
Contact