4.11. REPLACE INDUCTION HEATER RELAY

2. REMOVE RELAY WIRES - TM-5-3895-373-20_610

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
601

TM 5-3895-373-20 4.11. REPLACE INDUCTION HEATER RELAY. This task covers: a. Remove b. Install INITIAL SETUP: Tools: References: General mechanic’s automotive tool kit TM 5-3895-373-10 (Item 54, Appendix E) TM 5-3895-373-24P Torque wrench, 0 to 175 lb-ft (Item 68, Appendix E) Torque wrench, 5 to 150 lb-in (Item 69, Appendix E) Equipment Condition: Rear top left access door open per TM 5-3895-373-10. Materials/Parts: Left access cover removed per TM 5-3895-373-10. Electrical insulating varnish (Item 32, Appendix C) Thread locking compound (Item 13, Appendix C) Thread locking compound solvent (Item 25, Appendix C) Induction heater relay A. REMOVE. 1. REMOVE BATTERY CABLES. a. Unbuckle battery box holddown straps (1) and remove battery box covers (2) from both batteries. b. Lift rubber battery terminal caps (3) from battery terminals. When disconnecting batteries, disconnect negative battery cable before disconnecting positive battery cable. Failure to disconnect batteries in the proper sequence may lead to electrical shock or short circuit and result in severe personnel injury. c. Remove battery nut (4) and negative battery cable (5) from negative terminal of outboard battery. d. Remove battery nut (4) and positive battery cable (6) from positive terminal of inboard battery. GO TO NEXT PAGE 4-65

Privacy Statement
Press Release
Contact