TM 5-3895-385-23-2
0308
Hydraulic Oil Return Filter Element Removal -- Continued.
NOTE
It may be necessary to hold filter housing (not shown) in place to remove return element from
reservoir fill neck.
5. Remove O-ring (Figure 2, Item 4) from top of reservoir fill neck (Figure 2, Item 8). Discard O-ring.
6. Twist and remove return filter element (Figure 2, Item 6) from filter housing (not shown). Discard filter
element.
7. Remove O-ring (Figure 2, Item 7) from return filter element (Figure 2, Item 6) mount located inside filter
housing (not shown). Discard O-ring.
END OF TASK
Hydraulic Oil Return Filter Element Installation
1. Install new O-ring (Figure 2, Item 7) onto return filter element (Figure 2, Item 6) mount located inside filter
housing (not shown).
2. Install return filter element (Figure 2, Item 6) into filter housing (not shown) and onto return filter element
(Figure 2, Item 6) mount. Ensure return filter element is seated properly.
3. Install spring (Figure 2, Item 5) on top of return filter element (Figure 2, Item 6).
4. Install new O-ring (Figure 2, Item 4) into seat on top of reservoir fill neck (Figure 2, Item 8). Coat O-ring
(Figure 2, Item 4) with clean hydraulic oil.
NOTE
Maintain even pressure on hydraulic reservoir fill cap when installing flat washers and wing nuts.
Tighten wing nuts alternately around hydraulic reservoir fill cap to avoid binding and ensure a
level installation.
5. Install reservoir fill cap (Figure 2, Item 1) onto spring (Figure 2, Item 5) and threaded studs on reservoir fill
neck (Figure 2, Item 8), apply downward pressure to reservoir fill cap, and install three flat washers (Figure 2,
Item 3) and wing nuts (Figure 2, Item 2) onto top of reservoir fill neck (Figure 2, Item 8).
6. Close hydraulic reservoir fill cap access panel (Figure 1, Item 2).
7. Return left seat slide assembly (Figure 1, Item 1) to original position.
END OF TASK
FOLLOW-ON TASK
1. Clean any residual hydraulic oil, and dispose of soiled rags In Accordance With (IAW) local Standard
Operating Procedure (SOP).
2. Set BATTERY DISCONNECT switch to ON (TM 5-3895-385-10).
3. Verify proper operation.
END OF TASK
END OF WORK PACKAGE
