TM 5-3895-373-34
A.
REMOVE - Continued.
2.
REMOVE SHAFT AND BEARING UNITS FROM
THE PAVING MACHINE.
a.
Remove hex head cap screw (11), flat washer
(12), and clamp (13) from main frame (14).
b.
Remove hex nut (15), lockwasher (16), and hex
head cap screw (17) from shaft cover (18), and
remove the shaft cover from shaft (2). Discard
lockwasher.
WARNING
Bearing mount and shaft weigh 61 lbs
(28 kg). Equipment damage and
personnel injury could result from
dropping bearing mount and shaft
when removing from paving machine.
c.
With the help of another person, support the
weight of shaft (2) and bearing unit (10).
d.
Remove hex nuts (19), flat washers (20), and
hex head cap screws (21) from bearing mount
(22) and main frame (14). Remove sprocket
wheel (3) and square key (23) while pulling shaft
(2), bearing unit (10), and bearing mount from
the paving machine.
3.
REMOVE BEARING UNIT AND
BEARING
MOUNT FROM SHAFT.
a.
Remove lubrication pipe (24) from bearing unit
(10).
b.
Loosen set screws (25 and 26) on bearing units
(10 and 27).
c.
Use a hydraulic press and press shaft (2) from
bearing unit (10).
d.
Use a hydraulic press and press shaft (2) from
bearing unit (27) and bearing mount (22).
GO TO NEXT PAGE
2-959
