TM 5-3895-373-34
D.
INSTALL.
1.
INSTALL BEARING UNIT ON BEARING MOUNT.
a.
Install lubrication tube (31) onto bearing unit
(27). Ensure lubrication fitting is positioned on
bearing unit to point toward rear of paving
machine when bearing unit is mounted on main
frame.
b.
Install hex head cap screws (30) through bearing
mount (22) and into bearing unit.
c.
Install lockwasher (29) onto hex head cap screw
(30).
Sealing compound can cause eye
damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
d.
Apply sealing compound to threads of hex head
cap screw (30).
e.
Install hex nuts (28). Tighten hex nuts to 180 lb-
ft (244 N.m) using socket wrench adapter.
2.
INSTALL
BEARING
UNIT
ON
AUGER/
CONVEYOR DRIVE CHAIN HOUSING.
a.
Install lubrication pipe (24) onto bearing unit
(10). Ensure lubrication fitting is positioned on
bearing unit to point toward rear of paving
machine when bearing unit is mounted on
auger/conveyor drive chain housing.
b.
Place lockwashers (9) onto hex head cap screws
(8).
c.
Apply sealing compound to threads of hex head
cap screw (8).
d.
Install hex head cap screws (8) through bearing
unit (10) and into auger/conveyor drive chain
housing. Tighten to 180 Ib-ft (244 N.m) using
socket wrench adapter.
e.
Install washer (6) on hex head cap screw (5).
f.
Apply sealing compound to threads of hex head
cap screw (5).
g.
Install hex head cap screw (5) with washer (6)
and clamp (7) into main frame. Tighten to 9 lb-ft
(12 N•m).
GO TO NEXT PAGE
2-963
