TM 5-3895-373-34
2.68
REPLACE AUGER BEARING UNITS, SHAFT, AND SPROCKET WHEEL - Continued
D.
INSTALL - Continued
3.
INSTALL SHAFT
Shaft weighs 37 lbs (16,76 kg).
Equipment damage and personnel
injury could result from dropping the
shaft when attaching to main frame
NOTE
Square key must be inserted before
shaft
and
sprocket
wheel
are
installed. Ensure that sprocket wheel
keyway is in line with shaft keyway
prior to installing shaft.
a.
Insert square key (23) into shaft (2).
b.
Insert and hold sprocket wheel (3) in place in
auger/conveyor drive chain housing.
c
With a second person supporting the weight of
shaft (2), install shaft and square key (23) into
bearing unit (10).
d.
Align sprocket wheel keyway with shaft keyway.
Slide shaft (2) and square key (23) into sprocket
wheel (3) until it stops.
Sealing compound can cause eye
damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
e.
Apply sealing compound to threads of set
screws (26).
f.
Install set screws (26) and tighten.
g.
Apply sealing compound to threads of set
screws (4).
h.
Install
set
screws
(4)
and
tighten.
Use care when installing snap and
retaining rings Snap and retaining
rings are under spring tension and
can act as projectiles when released
and could cause severe eye injury
i.
Install retaining ring (1) on shaft
GO TO NEXT PAGE
2-964
