TM 5-3895-373-34
D.
INSTALL - Continued.
6.
ALIGN SPROCKET WHEEL.
a.
Use a machinist’s rule and align sprocket wheel
(20) with the auger/conveyor drive sprocket
wheel. Verify this alignment with the auger
sprocket wheel.
WARNING
Thread locking compound can cause
eye
damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
b.
Remove set screws (21) and apply thread
locking compound to the threads.
c.
Install set screws (21) into sprocket wheel (20)
and tighten to 19 lb-ft (26 N.m) using hex head
driver socket.
d.
Lubricate inner and outer bearing units (5 and 6)
per LO 5-3895-373-12.
NOTE
FOLLOW-ON-TASKS:
Install auger/conveyor drive chain per paragraph 2.63.
Install conveyor chain assembly per paragraph 2.61.
Install screed per TM 5-3895-373-20.
Lubricate bearings per LO 5-3895-373-12.
END OF TASK
2-883
