TM 5-3895-373-34
D.
INSTALL - Continued.
2.
ASSEMBLE DRIVE SHAFT.
a.
Slide sprocket wheels (19) onto drive shaft (18)
with hubs oriented toward the middle of the drive
shaft.
b.
Place keys (22 and 23) into key slots on drive
shaft (18) and slide sprocket wheels (19) over
the top of the keys. Snug set screws (7) enough
to keep the sprocket wheels in place. Do not
tighten set screws at this time.
c.
Install lubrication lines (4) into inner and outer
bearing units (5 and 6).
d.
Slide inner bearing unit (5) onto the drive end
(keyed end) of drive shaft (18) with the bearing
facing to the middle of the drive shaft.
e.
Slide outer bearing unit (6) onto the opposite end
of drive shaft (18) with the bearing facing to the
middle of the drive shaft.
f.
Position bearing plate (13) over drive shaft (18).
g.
Install sprocket wheel (20) and set screw (21)
onto drive shaft (18). Snug, but do not tighten
set screw.
GO TO NEXT PAGE
2-879
