TM 5-3895-373-34
2.64
REPLACE/REPAIR CONVEYOR DRIVE SHAFT, BEARING UNITS, AND SPROCKETWHEELS-Continued.
D.
INSTALL - Continued.
3.
INSTALL DRIVE SHAFT AS AN ASSEMBLY.
a.
With the help of a second person, slide the
outside end (non-keyed end) of the drive shaft
(18) through the outer access hole. Position the
drive shaft so the keyed end slides into the inner
access hole.
b.
Install flat washers (12) onto hex head cap
screws (11).
WARNING
Thread locking compound can cause
eye
damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
c.
Apply thread locking compound to the threads of
hex head cap screws (11).
d.
Install hex head cap screws (11) through bearing
plate (13) and into the paving machine. Tighten
cap screws to 90 lb-ft (122 N.m).
e.
Install flat washers (10) onto hex head cap
screws (9).
f.
Apply thread locking compound to threads of hex
head cap screws (9).
g.
Install hex head cap screws (9) through inner
bearing unit (5) and into bearing plate (13).
h.
Tighten hex head cap screws (9) to 90 lb-ft (122
N.m).
GO TO NEXT PAGE
2-880
