TM 5-3895-373-34
D.
INSTALL - Continued.
4.
LEVEL DRIVE SHAFT.
a.
Install flat washers (17) onto hex head cap
screws (16).
WARNING
Thread locking compound can cause eye damage.
Wear safety goggles/glasses when
using. Avoid contact with eyes. If
compound contacts eyes, flush eyes
with water and get immediate medical
attention.
b.
Apply thread locking compound to the threads of
hex head cap screws (16).
c.
Install hex head cap screws (16), flat washers
(15), and hex nuts (14) and secure outer bearing
unit (6) into place. Do not tighten at this time.
d.
Place a level along the surface of conveyor drag
plate (30). Place a second level along the top
side of drive shaft (18). Adjust outer bearing unit
(6) so the second level on the drive shaft
matches the level on the drag plate.
e.
Tighten hex nuts (14) to 90 lb-ft (122 N.m).
f.
Install lockwasher (2) to hex head cap screw (1).
g.
Apply thread locking compound to threads of hex
head cap screw (1).
h.
Secure lubrication line (4) in place with clamp (3)
and hex head cap screw (1). Tighten cap screw
to 108 lb-in (13 N-m).
i.
Repeat steps f through i for outer bearing unit (6)
lubrication line.
GO TO NEXT PAGE
2-881
