TM 5-3895-373-34
F.
ASSEMBLE.
1.
INSTALL BREATHER, GEARS, CONNECTOR
COVER PLATE, COVER PLATES, AND DRAIN
HOSE ELBOW.
Pipe sealant can cause eye damage or skin
irritation. Wash after skin contact. Wear
safety goggles/glasses when using. Avoid
contact with eyes or skin. If sealant contacts
eyes,
flush
eyes
with
water
and
get
immediate medical attention.
a.
Apply pipe sealant to threads of breather
(33). Install breather.
b.
Install gear (32).
NOTE
Rubber lip of seal must point toward inside
of pump drive gearbox.
c.
Install seal (31) by pressing hand tight into
connector cover plate (29). Press from the
engine side of connector cover plate, with
rubber lip pointing toward inside of pump
drive gearbox. Press seal until flush with
engine side of connector cover plate. Tap
lightly with a plastic hammer if necessary.
Uncured
gasket
sealing
compound
can
cause eye damage or skin irritation. Avoid
contact with eyes and skin. If compound
contacts eyes, flush eyes with water for 15
minutes
and
get
immediate
medical
attention. If sealing compound contacts
skin, remove from skin with a dry cloth or
paper towel and wash thoroughly with soap
and water. Sealing compound releases
acetic acid while curing. Use with adequate
ventilation.
d.
Apply
a
coating
of
gasket
sealing
compound
to
connector
cover
plate
mounting surface of pump drive gearbox.
e.
Aligning match marks, install connector
cover plate (29) onto pump drive gearbox
(11) and align hex head cap screw holes.
Thread locking compound can cause eye
damage. Wear safety goggles/glasses when
using.
Avoid
contact
with
eyes.
If
compound contacts eyes, flush eyes with
water and get immediate medical attention.
f.
Coat threads of hex head cap screws (30)
with thread locking compound.
g.
Install hex head cap screws (30) using
socket wrench adapter. Tighten to 85 lb-ft
(115 N•m).
h.
With the help of another person, turn pump
drive gearbox over with engine connection
side face down.
GO TO NEXT PAGE
2-387
