TM 5-3895-373-34 2.29 REPLACE/REPAIR PUMP DRIVE GEARBOX - Continued. B. DISASSEMBLE. 1. MATCHMARK COVER PLATES (26) AND PUMP DRIVE GEARBOX (11) FOR ASSEMBLY. 2. REMOVE HEX HEAD CAP SCREWS (27) AND COVER  PLATES  (26).    DISCARD  HEX  HEAD CAP SCREWS. 3. LIFT GEARS (28) FROM PUMP DRIVE GEARBOX BY TIPPING GEARS SLIGHTLY TO CLEAR GEAR BEARING POCKETS. 4. REMOVE  ELBOW  (12)  FROM  THE  BOTTOM OF PUMP DRIVE GEARBOX (11). 5. WITH    THE    HELP    OF    ANOTHER    PERSON, TURN   PUMP   DRIVE   GEARBOX   (11)   OVER WITH ENGINE CONNECTION SIDE FACE UP. 6. MATCH  MARK  CONNECTOR  COVER  PLATE (29)  AND  PUMP  DRIVE  GEARBOX  (11)  FOR REASSEMBLY. 7. REMOVE HEX HEAD CAP SCREWS (30) AND CONNECTOR COVER PLATE (29). A PLASTIC HAMMER MIGHT BE REQUIRED TO BREAK THE SEAL BETWEEN THE CONNECTOR    COVER    PLATE    AND    PUMP DRIVE GEARBOX  (11).    DISCARD  HEX  HEAD CAP SCREWS. Use    caution    when    removing    seal    from connector cover plate.  Scratched or dented seal   grooves   may   cause   oil   leakage   and equipment damage.  Do not scratch or dent seal groove in connector cover plate. 8. REMOVE  SEAL  (30)  BY  DRIVING  SEAL  OUT TOWARD    ENGINE    SIDE    OF    CONNECTOR COVER   PLATE   (29)   WITH   A   FLAT   BLADE SCREWDRIVER.    DISCARD  PLAIN  ENCASED SEAL. 9. LIFT GEAR (32) FROM PUMP DRIVE GEARBOX (11). 10. REMOVE BREATHER (33).   ", GO TO NEXT PAGE 2-384