TM 5-3895-373-34
2.29
REPLACE/REPAIR PUMP DRIVE GEARBOX - Continued.
A.
REMOVE - Continued.
Pump
drive
gearbox
weighs
approximately 150 lbs (68 kg). To
avoid personnel injury, ensure all
chains
and
hooks
are
in
good
condition and are of correct capacity.
Ensure overhead hoist is in good
working condition and hooks are
positioned correctly. Lifting hooks
must not be side loaded. Damage to
equipment and personnel injury can
result from unexpected movement of
pump drive gearbox.
e.
Install hex head screw caps (19) into the
front top hole on the left side of the pump
drive gearbox, and the rear top hole on the
right side of the pump drive gearbox.
f.
Remove hex head cap screws (20) and
lockwashers (21). Discard lockwashers.
g.
Attach chain assembly (22) to hex head
screw caps (19).
h.
Attach chain hoist (23) hook to chain
assembly. Take up slack in hoist.
GO TO NEXT PAGE
2-382
