TM 5-3895-373-34
G.
INSTALL.
1.
INSTALL
PUMP
DRIVE
GEARBOX
INTO
ENGINE COMPARTMENT.
a.
Install hex head screw caps (19) into the
front top hole on the left side of the pump
drive gearbox (11) and the rear top hole on
the right side of the pump drive gearbox.
Pump
drive
gearbox
weighs
approximately 150 lbs (68 kg). To
avoid personnel injury, ensure all
chains
and
hooks
are
in
good
condition and are of correct capacity.
Ensure overhead hoist is in good
working condition and hooks are
positioned correctly. Lifting hooks
must not be side loaded. Damage to
equipment and personnel injury can
result from unexpected movement of
pump drive gearbox.
b.
Attach chain assembly (22) hooks to hex
head screw caps (19).
All personnel must stand clear during
lifting operation. Do not allow pump
drive gearbox to swing while hanging
from overhead hoist. A swinging or
shifting load may cause injury or
death to personnel.
c.
Lift pump drive gearbox (11) slowly from
work area and into engine compartment
through front top right access door.
d.
Set pump drive gearbox down on cribbing.
GO TO NEXT PAGE
2-389
