TM 5-3895-373-20
C. ADJUST Continued.
j.
If throttle lever (23) is tight against low speed set
screw (34), set throttle control switch to MAX.
(1)
Remove cotter pin (21) and clevis pin (22).
(2)
Loosen hex nut (19) and screw clevis (20)
two turns further onto throttle control cable
(14). Tighten hex nut.
(3)
Position and hold throttle lever (23)
against
high
speed
set
screw
(29).
Reposition throttle control cable (14) by
loosening hex nut (27) and tightening hex
nut (24) until clevis (20) aligns with throttle
lever.
(4)
Install clevis pin (22) and cotter pin (21).
(5)
Set throttle control switch to IDLE. Check
position of throttle lever (23). Throttle lever
should be just touching adjustment screw
without putting pressure on throttle lever or
throttle control cable (14).
(6)
Repeat steps (1) thru (5) as required.
k.
If throttle lever (23) is not touching low speed set
screw (34), set throttle control switch to MAX.
(1)
Remove cotter pin (21) and clevis pin (22).
(2)
Loosen hex nut (19) and screw clevis (20)
two turns further out on throttle control
cable (14). Tighten hex nut.
(3)
Position and hold throttle lever (23)
against high speed set screw. Reposition
throttle control cable (14) by loosening hex
nut (24) and tightening hex nut (27) until
clevis (20) aligns with throttle control lever.
(4)
Install clevis pin (22) and cotter pin (21).
(5)
Set throttle control switch to IDLE. Check
position of throttle lever (23). Throttle lever
should be just touching low speed set
screw (34). If not just touching set screw,
repeat steps (1) through (5).
GO TO NEXT PAGE
4-77
