TM 5-3895-373-34D.INSTALL - Continued4.INSTALL BEARING MOUNT ON MAIN FRAMEBearing mount and shaft weigh 61 lb(28 kg). Equipment damage andpersonnel injury could result fromdropping the bearing mount andshaft when installing on main frame.a.With the help of another person, support theweight of shaft (2), and install bearing mount(22) onto the shaft.Sealing compound can cause eyedamage. Wear safetygoggles/glasses when using. Avoidcontact with eyes. If compoundcontacts eyes, flush eyes with waterand get immediate medical attention.b.Install flat washer (20) onto hex head cap screw(21) Apply thread locking compound to threadsof hex head cap screws.c.Install hex head cap screws (21) through bearingmount and into main frame.d.Install flat washers (20) and hex nuts (19) ontocap screws and hand tighten hex nuts. Do nottighten hex nuts at this time.e.Use a level and plumb and position shaft (2) sothat it is level with the paving machine. Tightenhex nuts (19) to 90 lb-ft (122 N•m).f. Install flat washer (12) onto hex head cap screw(11) Apply thread locking compound to threadsof hex head cap screw.g. Install hex head cap screw (11), flat washer (12),and clamp (13) into main frame (14). Tighten to9 lb-ft (11 N•m).h. Remove set screws (25) on bearing unit (10) andapply thread locking compound to threads of setscrews.i. Install set screws (25) into bearing unit (10) andtightenj. Place shaft cover (18) on end of shaft (2) andalign mounting holesk. Install hex head cap screw (17), lockwashers(16), and hex nut (15). Tighten hex nut to 45 lb-ft (61 N•m).GO TO NEXT PAGE2-965
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
