TM 5-3895-373-34
2.69
REPLACE/REPAIR AUGER/CONVEYOR MOTOR AND DRIVE SPROCKET WHEEL
This task covers:
a.
Remove
b.
Disassemble
c.
Clean
d.
Inspect
e.
Assemble
f.
Install
INITIAL SETUP
Tools:
Gasket
General mechanic’s automotive tool kit
Plain seal
(Item 106, Appendix D)
Preformed packings
Alignment stud (Item 1, Appendix C)
Rear motor seal kit
Bench vise (Item 112, Appendix D)
Seal kit
Cleaning brush (Item 12, Appendix D)
Shaft seal kit
Combination wrench (Item 116, Appendix D)
Crowfoot wrench (Item 125, Appendix D)
Personnel Required:
Drip pan (Item 64, Appendix D)
Two 62B construction equipment repairers to assist in the
Hydraulic press frame (Item 41, Appendix D)
removal and replacement of the auger/conveyor motor
O-ring tool (Item 103, Appendix D)
Shaft face seal tool (Item 16, Appendix C)
References:
Shaft face seal tool (Item 17, Appendix C)
TM 5-3895-373-10
Shaft seal bullet (Item 20, Appendix C)
TM 5-3895-373-20
Sling strap (Item 98, Appendix D)
TM 5-3895-373-24P
Steel machinist’s rule (Item 74, Appendix D)
Torque wrench, 5 to 150 lb-in (Item 129, Appendix D)
Equipment Condition:
Torque wrench, 150 to 750 lb-in (Item 130, Appendix D)
Screed removed per TM 5-3895-373-20
Torque wrench, 0 to 175 lb-ft (Item 132, Appendix D)
Center top right access door opened per TM 5-3895-373-10
Universal puller kit (Item 69, Appendix D)
Center top left access door opened per TM 5-3895-373-10
Vise jaw caps (Item 23, Appendix D)
Rear top right access door opened per TM 5-3895-373-10
Rear top left access door opened per TM 5-3895-373-10
Materials/Parts:
Evacuate oil from hydraulic system per paragraph 2.54
Cleaning cloth (Item 6, Appendix B)
Remove field relay per TM 5-3895-373-20 if removing left
Cleaning solvent (Item 31, Appendix B)
auger/conveyor motor
Electrical insulating compound (Item 10, Appendix B)
Electrical insulating varnish (Item 38, Appendix B)
Emery cloth (Item 5, Appendix B)
Grease (Item 18, Appendix B)
Hydraulic fitting sealant (Item 26, Appendix B)
Hydraulic oil (Item 21, Appendix B)
Lint-free cloth (Item 7, Appendix B)
Machinery wiping towel (Item 37, Appendix B)
Protective caps (Item 3, Appendix B)
Tags (Item 34, Appendix B)
Tape (Item 35, Appendix B)
Thread locking compound (Item 13, Appendix D)
Thread locking compound solvent (Item 32, Appendix B)
Tie wraps (Item 36, Appendix B)
GO TO NEXT PAGE
2-967
