TM 5-3895-373-34
2.69
REPLACE/REPAIR AUGER/CONVEYOR MOTOR AND DRIVE SPROCKET WHEEL - Continued
NOTE
Procedures
for
right
and
left
auger/conveyor motors are the same
except where noted in the text.
A.
REMOVE.
1.
REMOVE COVER.
a.
Remove hex head cap screws (1) and flat
washers (2).
b.
Close rear top left access door (3) and remove
socket head cap screw (4), flat washer (5), and
hex nut (6) securing left side of cover (7).
c.
Open rear top left access door (3) and close rear
top right access door (8) and remove socket
head cap screw (4), flat washer (5), and hex nut
(6) from right side of cover (7).
d.
Turn cover (7) sideways and remove from
cowling frame.
e.
Open rear top right access door (8).
2.
REMOVE
SCREED
HARNESS
ELECTRICAL
RECEPTACLE.
a.
Remove hex nut (9), flat washer (10), and
machine screw (11) from screed harness
electrical receptacle (12).
b.
Remove screed harness electrical receptacle
(12) from main frame and position so that the
receptacle
does
not
interfere
with
auger/conveyor motor removal.
GO TO NEXT PAGE
2-968
