TM 5-3895-373-34
2.69
REPLACE/REPAIR AUGER/CONVEYOR MOTOR AND DRIVE SPROCKET WHEEL- Continued
A.
REMOVE - Continued.
NOTE
Perform step 4 if removing left
auger/conveyor motor. Go to steps 5
and
6
if
removing
right
auger/conveyor motor.
4.
DISCONNECT SCREED BURNER FUEL LINE,
SCREED HYDRAULIC HOSES, AND TUBES AT
TRACTOR REAR BULKHEAD.
Cleaning solvent, P-D-680, is TOXIC
and flammable. Wear protective
goggles and gloves Use only in a well
ventilated area. Avoid contact with
skin, eyes, and clothes, and do not
breathe vapors. Keep away from heat
or flame. Never smoke when using
solvent; the flashpoint for Type m
cleaning solvent is 200°F (93,3°C)
Failure to do so may result in injury
or death to personnel.
If personnel become dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
a.
Clean area around screed fuel, hydraulic hose
and tube fittings with a cleaning cloth moistened
with cleaning solvent.
GO TO NEXT PAGE
2-970
