TM 5-3895-373-34
A.
REMOVE - Continued.
7.
REMOVE ROCKER SHAFT ASSEMBLY AND
PUSH
RODS
FROM
CYLINDER
HEAD
ASSEMBLY.
a.
Remove screws (47) and washers (48) from
rocker shaft assembly (49).
b.
Remove rocker
shaft
assembly
(49)
from
cylinder head assembly (15).
c.
Remove and discard preformed packing (50)
from recess in cylinder head assembly (15).
NOTE
Note the position that each push rod
is removed from to ensure correct
positioning during installation.
d.
Remove push rods (51) from cylinder head
assembly (15). Mark each push rod with the
position removed from to ensure that push rods
are positioned in the same location during
assembly.
8.
REMOVE ALTERNATOR BELT ADJUSTING
ARM.
a.
Hold pivot bolt (52) and loosen self-locking hex
nut (53).
b.
Loosen hex head cap screw (54). Remove
adjustment screw (55) and flat washers (56 and
57). Move belt adjusting arm (58) up and out of
the way. Reinstall adjustment screw (55) and
flat washers (56 and 57) back into alternator.
c.
Remove hex head cap screw (54), lockwasher
(59), belt adjusting arm (58) and sleeve spacer
(60).
GO TO NEXT PAGE
2-67
