TM 5-3895-373-34
B.
CLEAN - Continued.
CAUTION
Use caution when scraping gasket
sealing surfaces with putty knife.
Putty
knife
may
score
sealing
surfaces and debris may fall into
open ports. Failure to do so may
result in poor seal and component
damage.
3.
USE A PUTTY KNIFE, IF NECESSARY TO
REMOVE ANY GASKET MATERIAL FROM
SEALING SURFACES. DO NOT SCORE THE
SEALING SURFACE OR ALLOW ANY GASKET
MATERIAL TO FALL INTO THE OPEN PORTS.
4.
DRY ALL PARTS WITH A CLEAN, LINT-FREE
CLOTH.
C.
INSTALL.
1.
INSTALL
STUDS,
LIFTING
BRACKETS,
CYLINDER
HEAD
END
COVER,
AND
THERMOSTAT HOUSING TO THE CYLINDER
HEAD ASSEMBLY.
a.
Install studs (91, 90, 89, and 88) into cylinder
head assembly (15) using stud remover and
setter.
b.
Tighten studs (88) to 42 lb-ft (57 N•m) and studs
(89, 90, and 91) to 30 Ib-ft (41 Nm).
WARNING
Pipe sealant can cause eye damage
or skin irritation. Wash after skin
contact. Wear safety goggles/glasses
when using. Avoid contact with eyes
or skin. If sealant contacts eyes,
flush
eyes
with
water
and
get
immediate medical attention.
c. Apply pipe sealant to threads of pipe plug (92)
and install into cylinder head assembly (15).
Tighten plug.
GO TO NEXT PAGE
2-71
