TM 5-3895-373-34
2.15
REPLACE CYLINDER HEAD ASSEMBLY- Continued.
A.
REMOVE - Continued.
9.
REMOVE CYLINDER HEAD ASSEMBLY
FROM ENGINE BLOCK.
a.
Cut any tie wraps necessary and move the
wiring harnesses out of the way so that they
will not interfere with the removal of cylinder
head assembly (15).
b.
Remove and discard cylinder head machine
bolts (61, 62, and 63) from cylinder head
assembly (15) in the order shown.
c.
Attach a chain assembly to front and rear
lifting brackets (64 and 65).
WARNING
To avoid personal injury, use a
hoist when lifting the cylinder
head assembly, which weighs
more than 110 lbs (50 kg). Ensure
the chains and hooks are in good
condition
and
are
of
correct
capacity.
Ensure
hooks
are
positioned correctly.
Keep clear of paving machine
when the cylinder head assembly
is being raised. The cylinder
head assembly could fall and
cause serious injury or death.
Do not allow the cylinder head
assembly to swing while hanging
from the lifting device. The
cylinder
head
assembly
may
strike
personnel
and
cause
serious injury.
d.
Lift cylinder head assembly (15) off of engine
block (66) using an overhead hoist. Make
sure to hold all wiring harnesses out of the
way as the cylinder head assembly is being
lifted. Place the cylinder head assembly
onto a flat work surface and remove the
chain assembly.
e.
Remove and discard cylinder head gasket.
f.
Cover the open ports on engine block (66) with a lint-
free cloth until needed for installation.
GO TO NEXT PAGE
2-68
