TM 5-3895-373-34
2.15
REPLACE CYLINDER HEAD ASSEMBLY - Continued.
A.
REMOVE - Continued.
l.
Remove studs (88, 89, 90, and 91) using
stud remover and setter.
m.
Remove pipe plug (92) from cylinder
head assembly (15).
WARNING
Cleaning solvent, PD-680, is TOXIC
and flammable. Wear protective
goggles and gloves. Use only in a
well ventilated area. Avoid contact
with skin, eyes, and clothes, and do
not breathe vapors. Keep away from
heat or flame. Never smoke when
using solvent: the flashpoint for
Type III cleaning solvent is 200°F
(93,3°C). Failure to do so may result
in injury or death to personnel.
If personnel become dizzy when
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
B.
CLEAN.
1.
USE A CLEAN, LINT-FREE CLOTH
SOAKED IN CLEANING SOLVENT TO
CLEAN THERMOSTAT HOUSING (25),
VALVE COVER (42), ROCKER SHAFT
ASSEMBLY (49), PUSH RODS (51),
CYLINDER HEAD END COVER (75),
AND THE TOP OF ENGINE BLOCK (66).
2.
USE A PARTS CLEANING BRUSH AND
CLEANING
SOLVENT
TO
REMOVE
ANY HARD DEPOSITS AND CARBON
BUILDUP.
GO TO NEXT PAGE
2-70
