TM 5-3895-373-34
2.15
REPLACE CYLINDER HEAD ASSEMBLY - Continued.
C.
INSTALL Continued.
d.
Place thermostat housing gasket (87)
and
thermostat
housing
(25)
onto
cylinder head assembly (15). Secure in
place with lockwashers (78) and bolts
(77).
e.
Install lockwashers (80) and screws
(79).
f.
Install lockwasher (82) and screw (81).
g.
Install lockwasher (84) and bolt (83).
h.
Install lockwasher (86) and hex nut (85).
i.
Tighten bolts (77 and 83) and hex nut
(85) to 42 Ib-ft (57 N•m).
j. Tighten screws (79 and 81) to 21 lb-ft
(28 N•m).
WARNING
Pipe sealant can cause eye
damage
or
skin
irritation.
Wash
after
skin
contact.
Wear safety goggles/glasses
when using. Avoid contact
with eyes or skin. If sealant
contacts eyes, flush eyes with
water
and
get
immediate
medical attention.
k. Apply pipe sealant to the threads of
engine coolant temperature transducer
(39). Install transducer into thermostat
housing (25).
l. Install front and rear lifting brackets (64
and 65), lockwashers (69) and hex head
cap screws (68).
m. Tighten hex head cap screws (68) to 42
lb-ft (57 N•m).
n. Place end cover gasket (76) and
cylinder head end cover (75) onto
cylinder head assembly (15). Secure
with lockwasher (71), and screw (70).
o. Place washer (74) at the top center
position on cylinder head end cover (75).
Install lockwashers (73) and screws
(72).
p.
Tighten screws (72) to 42 lb-ft (N•m) and screw (70) to
21 lb-ft (28 N•m).
GO TO NEXT PAGE
2-72
