TM 5-3895-373-34 B. INSTALL - Continued. WARNING Thread    locking    compound    solvent can  cause  eye  damage.    Wear  safety goggles/glasses  when  using.    Avoid contact with eyes.  If solvent contacts eyes,  flush  eyes  with  water  and  get immediate medical attention. j. Remove    thread    locking    compound    from    hex head  ca]  screws  (1  and  6)  with  thread  locking compound solvent. k. Install flat washers (7) onto hex head cap screws (6) WARNING Thread locking  compound  can  cause eye damage. Wear safety goggles/glasses  when  using.    Avoid contact    with    eyes.        If    compound contacts  eyes,  flush  eyes  with  water and get immediate medical attention. l. Apply thread locking compound to threads of hex hex cap screws (6). m. Install retaining plate (8), retaining plate (9), and wing   flashing   (10)   and   tighten   hex   head   cap screws (6). n. Install flat washers (2) onto hex head cap screws (1). o. Apply thread locking compound to threads of hex head cap screws (1). CAUTION Ensure   that   center   flashing   is   not installed backward. Place reinforcement cords toward the inside of the hopper. p. Install retaining plate (4), center flashing (5), and hex     head     cap     screws     (1).          Ensure     that reinforcement cords are toward the inside of the hopper. q. Install and tighten hex nuts (3). NOTE If   immediately   replacing   hopper   lift cylinder, do not remove chain assemblies. r. Lower overhead hoist and remove chain assemblies (21) and C-clamps (20) from hopper wing (18). NOTE FOLLOW-ON-TASK:  Install hopper lift cylinder per TM 5-3895-373-20. END OF TASK 2-821