TM 5-3895-373-34 2.59 REPLACE HOPPER WING - Continued. B. INSTALL - Continued. WARNING All personnel must stand clear during lifting   operations.      Do   not   work   or move beneath hopper wing while it is being   removed.      Serious   injury   or death to personnel can occur. d. With the help of another person to steady hopper wing  (18),  lift  and  align  hopper  wing  hinge  with mating hinge on paving machine. 2. INSTALL HEADLESS STRAIGHT ROD. a. Lubricate full length of headless straight rod (23) with a thin coat of grease. b. Lift corner flap (22) on hopper wing (18). CAUTION Do  not  hammer  directly  on  headless straight   rod.      Install   hex   head   cap screw   and   use   a   wooden   block   to cushion  impact.    Failure  to  use  cap screw  and  wooden  block  will  cause damage to straight rod. c. Install and hand tighten hex head cap screw (24) in threaded end of headless straight rod (23). d. With  hopper  wing  hinge   and   mating   hinge   on paving  machine  aligned,  insert  tapered  end  of headless    straight    rod    (23)    into    hopper    wing hinge. e. Place a wooden block over headless straight rod and  drive  into  hinge.    Drive  until  straight  rod  is about 4 in.  (100 mm) from end of hinge. WARNING Thread locking  compound  can  cause eye damage. Wear safety goggles/glasses  when  using.    Avoid contact    with    eyes.        If    compound contacts  eyes,  flush  eyes  with  water and get immediate medical attention. f. Remove  hex  head  cap  screw  (24).    Install  flat washer (25) and apply thread locking compound to threads of hex head cap screw. g. Install  hex  head  cap  screw  (24).    Tighten  hex head cap screw. h. Place   a   wooden   block   against   hex   head   cap screw  (24)  and  drive  headless  straight  rod  (23) into hinge until fully seated. GO TO NEXT PAGE 2-818