TM 5-3895-373-34
B.
INSTALL - Continued.
3.
INSTALL SCRAPER.
WARNING
Thread locking compound solvent
can cause eye damage. Wear safety
goggles/glasses when using. Avoid
contact with eyes. If solvent contacts
eyes, flush eyes with water and get
immediate medical attention.
a.
Remove thread locking compound from hex
head cap screws (16) with thread locking
compound solvent.
b.
Dry parts with a clean, cleaning cloth.
c.
Install flat washers (17) onto hex head cap
screws (16).
WARNING
Thread locking compound can cause
eye
damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
d.
Apply thread locking compound to threads of hex
head cap screws (16).
e.
Install hex head cap screws (16) and scraper
(19) onto hopper wing (18).
f.
Position scraper (19) so there is a gap of 1/16 to
1/8 in. (1,5 to 3 mm) between the leading edge
of the scraper and the engine compartment
bulkhead.
g.
Raise and lower hopper wing (18) per TM 5-
3895-37310 to check clearance of scraper (19)
at compartment bulkhead. Ensure 1/16 to 1/8 in.
gap is held at closest point between scraper and
compartment bulkhead.
h.
Tighten hex head cap screws (16) to 59 lb-ft (80
N.m)
GO TO NEXT PAGE
2-819
