TM 5-3895-373-34
2.59
REPLACE HOPPER WING - Continued.
A.
REMOVE - Continued.
4.
REMOVE HEADLESS STRAIGHT ROD.
a.
Lift corner flap (22) to access headless straight
rod (23).
b.
Remove hex head cap screw (24) and flat
washer (25). Discard hex head cap screw and
flat washer.
c.
Install hex head cap screw (26) from tools list
into end of straight rod (23).
d.
Attach vise grip to head of hex head cap screw
(26).
WARNING
Do not raise hopper wing (18) to its
full height. Raise hopper wing only
as far as needed to relieve weight on
headless straight rod (23). Hopper
wing can move unexpectedly when
straight rod is pulled out. Personnel
injury, and equipment damage, can
result from unexpected movement.
e.
Raise hopper wing (18) using overhead hoist,
enough to relieve weight of hopper wing on
headless straight rod.
f.
Use vice grip to turn installed hex head cap
screw (26) and headless straight rod (23)
clockwise. Keep pulling on straight rod while
turning. Work straight rod out of hopper wing
hinge. Discard headless straight rod.
g.
Remove vise grip and hex head cap screw (26)
from straight rod (23).
GO TO NEXT PAGE
2-816
