TM 5-3895-373-34
D.
ASSEMBLE - Continued.
3.
INSTALL
ASSEMBLED
CROSS
AND
MOUNTING BRACKET.
WARNING
Pipe sealant can cause eye damage
or skin irritation. Wash after skin
contact. Wear safety goggles/glasses
when using. Avoid contact with eyes
or skin. If sealant contacts eyes,
flush
eyes
with
water
and
get
immediate medical attention.
a.
Apply pipe sealant to threads of elbow (13).
b.
Install elbow (13) and cross (14) into the single
port side of auger/conveyor speed control valve
(3) as shown.
c.
Apply pipe sealant to elbow (11) and install into
rear port on the two port side of auger/conveyor
speed control valve (3) for the right side valve,
and a straight adapter (12) for the left side valve.
Point the exposed thread end of the elbow in the
direction shown.
d.
Apply pipe sealant to threads of straight adapter
(10) and install into the front port on the two port
side of auger/conveyor speed control valve (3).
WARNING
Hydraulic fitting sealant can cause
eye damage or skin irritation. Wash
after skin contact. Wear safety
goggles/glasses when using. Avoid
contact with eyes or skin. If sealant
contacts eyes, flush eyes with water
and get immediate medical attention.
e.
Apply hydraulic fitting sealant to exposed thread
end of straight adapter (10).
f.
Install swivel elbow (9) onto straight adapter
(10). Orient swivel elbow as shown.
GO TO NEXT PAGE
2-661
