TM 5-3895-373-34
2.48
REPAIR AUGER/CONVEYOR SPEED CONTROL VALVE - Continued. ’,_
D.
ASSEMBLE - Continued.
i.
Use a hammer and drive roll pin (27)
halfway into adapter (23). Ensure that the
roll pin is not damaged during installation.
NOTE
If new detent ring is being installed,
roll pin (37) will be present. Remove
roll pin.
j.
If installed, remove roll pin (37) from detent
ring (26).
k.
Install detent ring (26).
Thread locking compound can cause
eye
damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
l.
Apply thread locking compound (Item 14,
Appendix B) to threads of set screw (25).
m.
Install and tighten set screw (25) into detent
ring (26).
n.
Install and tighten adapter (23) into valve
body (24) using the combination wrench.
Pipe sealant can cause eye damage
or skin irritation. Wash after skin
contact. Wear safety goggles/glasses
when using. Avoid contact with eyes
or skin. If sealant contacts eyes,
flush
eyes
with
water
and
get
immediate medical attention.
o.
Apply pipe sealant to threads of spring caps
(20).
p.
Install balls (22) and springs (21) and
tighten spring caps (20) into adapter (23).
GO TO NEXT PAGE
2-658
