TM 5-3895-373-34
2.49
REPAIR AUGER/CONVEYOR, VALVE AND CYLINDER, AND TOW POINT FLOW DIVIDERS - Continued.
A.
DISASSEMBLE - Continued.
4.
REMOVE
RETAINING
RINGS,
GEARS,
DOWEL KEYS, AND SHAFTS FROM SPACER
PLATE.
WARNING
Use care when removing retaining
rings. Retaining rings are under
spring
tension
and
can
act
as
projectiles when released and could
cause severe eye injury.
a.
Remove retaining rings (27) on outer side of
shafts (28) with snap ring pliers.
NOTE
Gears shown are for auger/conveyor
and valve and cylinder flow dividers.
Gears for tow point flow divider are
narrower
than
those
in
auger/conveyor
and
valve
and
cylinder flow dividers. Procedure for
removal is the same for all units.
b.
Slide gears (29) off of shafts (28).
NOTE
Illustration
shown
is
for
auger/conveyor
and
valve
and
cylinder flow dividers. If tow point
flow divider gear and shaft assembly
is being disassembled, metal balls
will be removed from shaft instead of
dowel keys. Only 3 metal balls are
used. Procedure for disassembly is
the same for all units.
c.
Remove dowel keys (30) or metal balls (31) from
shafts (28).
d.
Slide shafts (28) through bearings (26) in spacer
plate (22).
e.
Remove retaining rings (27) on inner side of
shafts (28) with snap ring pliers.
GO TO NEXT PAGE
2-666
