TM 5-3895-373-34
E.
ASSEMBLE Continued.
8.
INSTALL CYLINDER BLOCK ASSEMBLY.
Hydraulic oil can be moderately flammable
and can be an irritant to the skin, eyes, and
respiratory
system.
Avoid
prolonged
exposure. Eye protection and rubber
gloves must be worn when working with
hydraulic oil.
a.
Lubricate valve plate (103) with clean hydraulic
oil.
Cylinder block assembly is held together by
fitted parts. Do not allow cylinder block
assembly to fall apart during installation into
end cap housing. Cylinder block assembly
may fall apart if not lifted correctly.
b.
Use a pair of snap ring pliers and grasp cylinder
block assembly (96) on inner splined opening.
c.
Lower cylinder block assembly (96) into end cap
assembly housing. Seat cylinder block assembly
onto valve plate (103).
NOTE
Cylinder block bore must be aligned with
needle bearing bore to permit installation of
pump shaft.
GO TO NEXT PAGE
2-419
