TM 5-3895-373-34
2.30
REPLACE/REPAIR PROPULSION PUMP - Continued.
E.
ASSEMBLE Continued.
11.
INSTALL
ELECTRONIC
DISPLACEMENT
CONTROL.
NOTE
If pump pilot control valve is being
installed, refer to paragraph 2.31.
a.
Lubricate preformed packings (79, 80, and 81)
with petrolatum.
b.
Install preformed packings (79, 80, and 81) onto
electronic displacement control.
c.
Align and install spool (82) slotted end to engage
swash plate pin. Ensure retaining ring on control
sleeve is seated against end cap assembly
housing.
d.
Install hex head cap screws (76 and 77) through
electronic displacement control (78) and into end
cap assembly housing. Use socket wrench
adapter and hex head driver socket and tighten
to 10 lb-ft (14 N•m). Ensure preformed packings
stay in place on electronic displacement control
during installation.
12. INSTALL REMOTE FILTER ADAPTER ONTO END
CAP ASSEMBLY HOUSING.
a. Install hex head cap screws (73) through remote
filter adapter (74) and filter adapter seal (75).
b. Install hex head cap screws (73) into end cap
assembly housing. Tighten cap screws to 19 lb-
ft (25 N•m)..
GO TO NEXT PAGE
2-422
