TM 5-3895-373-34
2.30
REPLACE/REPAIR PROPULSION PUMP - Continued.
C.
CLEAN Continued.
Compressed air used for cleaning purposes
will not exceed 30 psi (207 kPa). Use only
with effective chip guarding and personal
protective equipment (goggles/face shield
and gloves). Failure to take proper
precautions may result in severe injury or
loss of vision.
b.
Use 30 psi (207 kPa) maximum compressed air
to remove any foreign matter from end cap
assembly housing, threaded surfaces, bores,
valve seats, and bearings.
c.
Dry all parts with a clean, lint-free cloth.
2.
CLEAN CAP SCREWS.
Thread locking compound solvent can
cause
eye
damage.
Wear
safety
goggles/glasses when using. Avoid contact
with eyes. If solvent contacts eyes, flush
eyes with water and get immediate medical
attention.
a.
Clean cap screws used to mount propulsion
pump to pump drive gearbox with thread locking
compound solvent.
b.
Wipe cap screws dry with a clean, lint-free cloth.
3.
WIPE HYDRAULIC FITTING SEALANT RESIDUE
FROM HYDRAULIC OIL TEMPERATURE
SENSOR AND STRAIGHT ADAPTER WITH A
CLEANING CLOTH.
GO TO NEXT PAGE
2-410
