TM 5-3895-373-34B.DISASSEMBLE Continued.11.REMOVE PUMP SHAFT, BEARING, ANDSLEEVE BEARINGS.Use care when removing retaining rings.Retaining rings are under spring tensionand can act as projectiles when releasedand could cause severe eye injury.a.Use snap ring pliers and remove retaining ring(90) from front cover (83).b.Pull pump shaft (91) and bearing (92) from frontcover.c.Remove sleeve bearings (93) from front cover.d.Remove retaining ring (94) from pump shaft.e.Use a bearing puller from universal puller kit toremove bearing (92).f.Remove retaining ring (95) from pump shaft.12.REMOVE CYLINDER BLOCK ASSEMBLY.Cylinder block assembly is held togetherby fitted parts. Do not allow cylinder blockassembly to fall apart during removal fromend cap assembly housing. Cylinder blockassembly may fall apart if not liftedcorrectly.a.Use snap ring pliers to grasp cylinder blockassembly (96) on inner splined opening.b.Lift cylinder block assembly (96) from end capassembly housing.c.Set cylinder block assembly down on clean worksurface.GO TO NEXT PAGE2-405
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
