TM 5-3895-373-34
D.
INSPECT Continued.
7.
INSPECT
RETAINER
GUIDE
AND
SLIPPER
RETAINER FOR SCORING.
a.
Visually inspect retainer guide (100), surface L,
and slipper retainer (98), surface M, for scoring.
b.
Replace retainer guide (100) and slipper retainer
(98) if scoring is detected.
8.
INSPECT
CYLINDER
BLOCK
BORES
AND
RUNNING FACE FOR NICKS, SCRATCHES, AND
SCORING.
a.
Inspect cylinder block (99) surfaces N, 0, and P
for nicks, scratches, and scoring.
b.
Use emery cloth to remove nicks and scratches.
Clean cylinder block (99) after removing nicks
and scratches. Refer to cleaning procedure.
c.
Replace
cylinder
block
(99)
if
scoring
is
detected, or if nicks and scratches cannot be
removed with emery cloth.
9.
INSPECT
VALVE
PLATE
FOR
NICKS,
SCRATCHES, AND SCORING.
a.
Visually inspect valve plate (103), surface Q, for
nicks, scratches, and scoring.
b.
Use emery cloth to remove nicks and scratches.
Clean valve plate (103) after removing nicks and
scratches. Refer to cleaning procedure.
c.
Replace valve plate (103) if scoring is detected,
or if nicks and scratches cannot be removed with
emery cloth.
10.
INSPECT CONTROL SLEEVE AND SPOOL FOR
NICKS, SCRATCHES, AND SCORING.
a.
Visually inspect control sleeve on electronic
displacement control (78) and spool (82) for
nicks, scratches, and scoring.
b.
Use emery cloth to remove nicks and scratches.
Clean control sleeve and spool (82) after
removing nicks and scratches. Refer to cleaning
procedure.
c.
Replace electronic displacement control (78) if
scoring is detected, or if nicks and scratches
cannot be removed with emery cloth.
GO TO NEXT PAGE
2-413
