TM 5-3895-373-34
2.19
REPLACE/REPAIR FUEL INJECTION PUMP- Continued.
B.
DISASSEMBLE - Continued.
i.
Remove hex head cap screws (35 and 36) and
washer (37). Discard washer.
j.
Cut and remove wire rope (38). Discard wire
rope.
k.
Remove sleeve (39), hex head cap screw (40),
nut (41), and flat washer (42).
l.
Install protective cap from DPA tool kit onto
throttle shaft (43).
m.
Remove control cover (44), and at the same
time, press down on protective cap with a finger,
pressing throttle shaft (43) from control cover
(44).
n.
Remove seals (45). Discard seals.
o.
Remove gasket (46). Discard gasket.
p.
Transfer protective cap from DPA tool kit to
shutoff spindle (47).
q.
Press shutoff spindle (47) out of control cover
(44) with a finger.
r.
Remove seals (48). Discard seals.
2.
REMOVE SPRING, THROTTLE SHAFT, SPRING
HOLDER,
SPRING,
SHUTOFF
BAR,
SHOULDERED
STUDS,
KEEP
PLATE,
AND
THROTTLE SHAFT.
a.
Remove spring (49) from throttle shaft (43).
b.
Remove spring holder (50) and spring (51).
c.
Remove shutoff bar (52).
d.
Press tabs down on lockwashers (53 and 54)
with a flat-blade screwdriver.
e.
Remove shouldered studs (55), lockwashers
(53),
keep
plate
(56),
screw
(57),
and
lockwasher (54). Discard lockwashers.
GO TO NEXT PAGE
2-252
