TM 5-3895-373-34
B.
DISASSEMBLE Continued.
9.
LOOSEN AND REMOVE OUTER ROTOR HEAD
ASSEMBLY AND SEALING RING.
NOTE
The direction to slacken the transfer
pump rotor is marked by an arrow on the
face of the outer rotor head assembly.
a.
Use a spanner wrench from DPA tool kit to hold
drive hub (104) while loosening pump impeller
(105) with spanner wrench from DPA tool kit.
b.
Remove tools and finger tighten pump impeller
(105) inside fuel injection pump.
c.
Remove hex head cap screw (106), fluid flow
restrictor (107), and washer (108). Discard
washer.
d.
Remove hex head cap screw (109) and washer
(110). Discard washer.
e.
Remove outer rotor head assembly (11 I) with a
slight twisting motion side-to-side while gently
pulling from fuel injection pump.
f.
Remove sealing ring (112). Discard sealing ring.
GO TO NEXT PAGE
2-257
