TM 5-3895-373-34
B.
DISASSEMBLE Continued.
6.
LOOSEN SCREW AND REMOVE FUEL BANJO
BOLTS, FLUID PASSAGE BOLTS, AND END
PLATE ASSEMBLY.
a.
Use a socket from DPA tool kit to loosen screw
(80).
b.
If necessary, tap screw (80) gently with a plastic
hammer to release.
c.
Turn fuel injection pump over so top is facing up.
d.
Remove banjo bolts (81), flat washers (82),
banjo bolt (83), and fluid passage bolt (84).
Discard flat washers.
e.
Remove hex head cap screws (85), clamp (86),
and end plate assembly (87).
GO TO NEXT PAGE
2-255
