TM 5-3895-373-34
2.17
DIESEL ENGINE REPAIR - Continued.
E.
INSTALL - Continued.
6.
INSTALL SLEEVE BUSHING, GUDGEON PIN,
RETAINING
RINGS,
SLEEVE
BEARINGS,
AND
CONNECTING ROD ASSEMBLIES ONTO PISTON.
NOTE
New sleeve bushings will need to be
machined to match profile of small
end on connecting rod assembly.
a.
Install sleeve bushing (106) into connecting
rod assembly (99) using hydraulic press frame
and universal puller kit. Ensure oil hole in sleeve
bushing aligns with oil hole in connecting rod
assembly.
b.
Ream new sleeve bushings to correct size and
align with gudgeon pin. Refer to service wear
limits section.
NOTE
Cavity on top of piston is offset
toward rod and cap identification
number on connecting rod assembly.
Piston and connecting rod assembly
must be assembled with piston cavity
offset
toward
rod
and
cap
identification number on connecting
rod assembly.
c.
Place connecting rod assembly (99) inside
piston (98), with piston cavity offset toward rod
and cap identification number on connecting rod
assembly.
d.
Install gudgeon pin (105) through piston (98) and
connecting rod assembly (99).
GO TO NEXT PAGE
2-218
