TM 5-3895-373-34
E.
INSTALL - Continued.
8.
INSTALL SPUR GEARS, BALANCER UNIT
FRAME END, OIL PUMP, GEAR SHAFT, OIL RELIEF
VALVE, AND TIMING GEAR ONTO BALANCER UNIT.
a.
Lubricate sleeve bushings (172) in balancer unit
frame end (91) and frame (94) with clean engine
oil.
Spur gears are heavy and may damage
sleeve bushings when installed. Do not
damage sleeve bushings when installing
gears. Install gears slowly and keep
gears level with balancer unit frame
during installation.
b.
Install spur gears (93 and 92) into balancer unit
frame (94), with flat areas in line with one
another.
c.
Install balancer unit frame end (91) and bolts (90
and 89). Tighten to 40 lb-ft (54 Nom).
Uncured gasket sealing compound
can
cause
eye
damage
or
skin
irritation. Avoid contact with eyes and
skin. If compound contacts eyes,
flush eyes with water for 15 minutes
and get immediate medical attention.
If sealing compound contacts skin,
remove from skin with a dry cloth or
paper towel and wash thoroughly with
soap and water. Sealing compound
releases acetic acid while curing. Use
with adequate ventilation.
d.
Apply a thin coating of gasket sealing compound
to both sides of gasket (88).
e.
Install
gasket
(88)
and
cover
(87),
with
hexagonal symbol on right and square symbol
on left.
f.
Install screws (86). Tighten to 24 lb-ft (33 N.m).
GO TO NEXT PAGE
2-221
