TM 5-3895-373-34
2.17
DIESEL ENGINE REPAIR - Continued.
E.
INSTALL - Continued.
4.
INSTALL AND ALIGN FLYWHEEL HOUSING ON
ENGINE BLOCK.
a.
Attach two hex head screw caps to inner most
flywheel housing lifter holes.
Personnel shall stay clear of objects
being lifted during hoist operations.
Do not work on objects suspended
by a hoist. A swinging or shifting
load may cause injury or death to
personnel.
Do not work on any item supported
only by lift jacks or hoist. Always use
blocks or proper stands to support
the
item
prior
to
any
work.
Equipment
may
fall
and
cause
serious injury or death to personnel.
Do not allow heavy components to
swing while hanging by lifting device.
Equipment may strike personnel and
cause serious injury.
Exercise
extreme
caution
when
working near a cable or chain under
tension. A snapped cable or a
shifting or swinging load may cause
injury or death to personnel.
b.
Attach chain hoist to hex head screw caps.
c.
Remove any dirt or foreign material on mating
surfaces of flywheel housing (119) and engine
block with a cleaning cloth.
d.
Lift flywheel housing (119) into position on
engine block dowel pins.
e.
Align and seat flywheel housing (119) on rear of
engine block.
f.
Install lockwashers (118) and bolts (117).
Tighten bolts to 36 lb-ft (48 N•m).
GO TO NEXT PAGE
2-214
