TM 5-3895-373-34
2.15
REPLACE CYLINDER HEAD ASSEMBLY - Continued.
C.
INSTALL - Continued.
h.
Remove bolts (63) used for alignment.
i.
Lightly oil bolts (61, 62, and 63) with engine oil.
j.
Install bolts (61) short, (62) medium, and (63)
long, into cylinder head assembly (15). Ensure
that the correct size bolt is installed into the
correct hole as shown. Place short bolts (61) in
holes marked S, medium bolts (62) in holes
marked M, and long bolts (63) in holes marked
L.
k.
Tighten the bolts to 89 Ib-ft (121 N•m) in the
sequence shown.
l. After tightening, verify that all of the bolts are set
to the proper torque before continuing on to the
next step.
m. Tighten each bolt another one half turn (180°) in
the sequence shown.
GO TO NEXT PAGE
2-74
