TM 5-3895-373-34
2.69
REPLACE/REPAIR AUGER/CONVEYOR MOTOR AND DRIVE SPROCKET WHEEL - Continued.
F.
INSTALL.
1.
INSTALL AUGER/CONVEYOR MOTOR ONTO
PAVING MACHINE MAIN FRAME.
a.
Position auger/conveyor motor and motor
mount with flat area of motor mount down.
b.
Using an overhead hoist and sling strap,
lower auger/conveyor motor into mounting
location in main frame.
Hydraulic
oil
can
be
moderately
flammable and can be an irritant to
the
skin,
eyes,
and
respiratory
system. Avoid prolonged exposure.
Eye protection and rubber gloves
must be worn when working with
hydraulic oil.
Be careful not to damage preformed
packing when sliding over threads.
Sharp edges of thread can cut or
damage
preformed
packing.
Damaged
preformed
packing
will
cause
leakage
and
affect
performance.
c.
Lubricate preformed packings (51) with
clean hydraulic oil and install onto straight
adapters (50).
d.
Use a 1-1/2 in. combination wrench and
install and tighten straight adapters (50) into
the ports of auger/conveyor motor (59).
e.
Rotate motor mount and align motor mount
with mounting holes in paving machine
main frame.
f.
Install flat washers (44), washers (43), and
hex head cap screws (40). Snug, but do
not tighten, cap screw.
GO TO NEXT PAGE
2-998
